Masport Clutha Ash ULEB details

Back to burner list
Appliance name Masport Clutha Ash ULEB
Situation Freestanding
Fuel type Dry Wood
Emission 35 mg/MJ
Emission factor 0.43 g/kg
Efficiency 66 %
Water heater None
Approval number 232830

Conditions

  1. The only fuel to be used in this appliance shall be softwood that meets the following criteria:
    1. Less than 25% moisture (dry weight);
    2. Has not been treated with preservatives or impregnated with chemicals or glue;
    3. Is not chipboard, particle board, or laminated board; and
    4. Is not painted, stained or oiled.
  2. The appliance shall be operated at all times in accordance with the “Owner Manual” supplied with each appliance.
  3. There shall be no wetback fitted to the appliance.
  4. There shall be no air circulation fan fitted to the appliance.
  5. A permanent label shall be attached to each appliance in a position that is readily visible after installation. The label shall contain the following information:
    1. The manufacturer of the appliance (Glen Dimplex New Zealand Limited);
    2. The unique model name (Masport Clutha Ash ULEB);
    3. The unique serial number of the appliance;
    4. The number of the test report in which the appliance is described (0644a);
    5. The name and address of the testing agency (Spectrum Laboratories Ltd, 9B Lady Ruby Drive, East Tamaki, Auckland);
    6. The year in which the testing was completed (2022);
    7. The authorisation number (232830);
    8. The approved fuel for use in the heater (softwood);
    9. The measured (average) particulate emission rate in grams per kilogram (0.43 g/kg);
    10. The measured emission rate per unit of useful heat output (35 mg/MJ);
    11. The percentage measure of thermal efficiency (66%);
    12. The range of average heat outputs tested (3.3 – 9.7 kW);
    13. The maximum average heat output (9.7 kW);
    14. The statement “Performance may vary from test values depending on the actual operating conditions”; and
    15. Space to allow the installer to place the date of installation.
  6. This approval applies only to the specific model described in the documents and drawings accompanying the application for authorisation.

    Advice note:
    Any necessary building consents, for the installation of the appliance, must be obtained from the appropriate district or city council.